34
August 2009 Plasma 50PS80
LVDS Cable Connector
Lay the Plasma down carefully on a padded surface.
Make sure AC is removed and remove the Back Cover and the
Stand.
Carefully remove the LVDS Cable
P203
from the Main Board by
lifting the Locking Tab upward and pull the ribbon cable free. (See
illustration to the right). This prevents possible damage to the cable.
(A) Remove the Stand (4 Screws removed during back removal)
Pull the stand out of the stand support bracket.
(B) Remove the Stand Metal Support Bracket (5 Screws).
(C) On the Main board, remove connectors P1108, P1101 and P900.
The LVDS connector should already be removed (see above).
(D) Remove the 4 screws from the Main Board Mounting Bracket.
(Note: Decorative Plastic Piece on right does not need to be removed)
Carefully reposition the Main Board and Mounting Bracket up and off to the right side.
(E) Remove the metal support Braces marked “E”. Note: There is a Left and a Right brace.
(3 Screws per/bracket).
(F) Remove the 13 screws holding the Heat Sink.
Removing the X Drive Circuit Board
Removing the X Drive Circuit Board
PROCEDURE: (See Figure on next page).
Flip up the Locking Tab
X-DRIVE PWBs REMOVAL:
Disconnect all TCP ribbon cables from the defective X-Drive PWB.
Remove the 5 screws holding the PWB in place.
Remove the PWB. Reassemble in reverse order. Recheck Va / Vs / VScan / -VY / Z-Bias.
Содержание 50PS80 Series
Страница 18: ...18 August 2009 Plasma 50PS80 Remote Control Remote Control TOP PORTION BOTTOM PORTION ...
Страница 122: ...122 August 2009 Plasma 50PS80 Main PWB Main PWB Semiconductor Semiconductor Component Component Voltages Voltages ...
Страница 134: ...134 August 2009 Plasma 50PS80 Side Key Assembly Side Key Assembly c To Ft IR PWB P1 SW8 SW2 SW6 SW7 SW4 SW5 SW3 SW1 c ...
Страница 139: ...This concludes the Presentation Thank You End of Presentation End of Presentation ...