Leyman TLS3510RL Hide-A-Way, Руководство по установке

Страница: 19 / 28

19
FINAL INSTALLATION INSPECTION
CUSTOMER:
LOCATION:
VEHICLE#: LIFT GATE MODEL#: LIFT GATE SERIAL#:

= OK N = NOT APPLICABLE
WELDING/ADJUSTMENTS
Gate is welded secure to bottom of cross members
Up stops are adjusted (to set platform flush with floor of trailer) and tack welded to compression arm
Out stops adjusted (the platform should be ¼” to ½” from the edge of the threshold)
In stops adjusted (the auto lock pin should be ¼” gap from hook)
ELECTRIC’S
Check that battery holds downs are anchored securely
Check batteries for proper charge level.
Check all wiring connections for tightness (batteries, switches, etc.) and sealer has been applied.
Inspect and check all circuit breakers
Charge line/power line (through cross members with rubber grommets if this is the preferred method)
Charge line/power line (clamped to bottom of cross members with loom clamps)
Control wiring has been properly routed and secured
Check operation of toggle switches (or walk around if equipped)
Check operation of optional lights if equipped
HYDRAULIC/GREASE
Check reservoir for correct amount of fluid
. Fluid level should be within 1” of the top of the tank.
Platform should be down on the ground when checking fluid level.
Refer to the Recommended hydraulic oil / lubrication page for type of oil and capacity.
Check hydraulic hoses and fittings for leaks
Check hydraulic cylinders for leaks
OPERATION OF GATE
Raise and lower lift gate. Observe for correct operation
Operate lift gate in-out. Observe for correct operation
PAINTING AND SAFETY STICKERS
Repaint where needed. Use Leyman Extreme Shield
®
touch-up kit provided.
Check hydraulic cylinder rods for over spray
Install all safety and operation stickers
SERVICED BY: _____________________________________________________________
DATE: ________________________________