Leyman TLS3510RL Hide-A-Way, Руководство по установке

Страница: 17 / 28

17
INSTALLATION ADJUSTMENTS
FLOOR
CROSS BEAMS
1/4 TO 1/2
STRAIGHT EDGE
SIDE DOOR THRESHOLD
OUT STOP ADJ
UP STOP ADJ
IN STOP ADJ
PLATFORM TILT ADJ
AUTO LOCK AREA
1/4
LOCK PIN ON
PLATFORM
AUTO LOCK AREA
Step 1: The platform was preset at the factory to be level to the floor of the tr
ailer within ¼”.
With a straight edge, check this. If it is okay, proceed to step 2. If not, let the platform
down to the ground. Remove the two (2) roll pins and the top tension arm pivot pins
(one on each side).
NOTE: One full turn moves the tip of
the platform ¼” (turn the end in, this moves the tip
of the platform up, unscrewing moves the tip of the platform down.)
Make necessary adjustments. Replace pins, raise the platform up and check. Repeat if
necessary. Replace roll pins.
NOTE: Each side must be adjusted the same amount.
CAUTION: If this adjustment has been made, the in-stop must be adjusted to provide
the ¼” clearance with the auto locking pin (see sketch 2).
Step 2: Adjust the up stops. Platform should be even with the floor of the trailer. After adjusting,
tack weld the stops in place.
Step 3:
Adjust the out stops. The tip of the platform should be ¼” to ½” from the edge of the
threshold.
Step 4:
Adjust the in stops. See sketch 2 and adjust for the ¼” dimension.
SKETCH 2