LEYBOLD RUVAC WA 40000, Инструкция по установке и эксплуатации

Страница: 19 / 44

Installation
300692481_002_C0 – 08/2018 – © Leybold 19
3 Installation
CAUTION
Liability or warranty claims will not be accepted if the installation includes any modifications or
additions to the pump without the prior written approval, or if the pump is incorrectly installed.
3.1 Installation safety
WARNING
Obey the safety instructions listed below and take note of appropriate precautions
while installing the pump. Failure to follow the instructions can cause injury to
people and damage to equipment.

Only a trained and competent engineer may carry out the installation of the
RUVAC WA 40000 pump. For advice contact your local customer centre.

Disconnect the other components in the pumping system from the electrical supply so that
they cannot be operated accidentally.

Ensure that the cooling air flow through the pump motor cooling fan cannot be obstructed.

Ensure that all electrical cables, purge gas pipelines and cooling water pipelines are safely
positioned, secured and routed, so that they do not present a trip hazard.

Leak test the system after installation work is complete and seal any leaks found to prevent
leakage of hazardous substances out of the system and leakage of air into the system.
3.2 Unpack and inspect
WARNING
Use suitable lifting equipment to move the pump. Failure to follow the instructions
can cause injury to people or damage the pump. Refer to section 2.5 for the mass
of the pump.
1. Use a suitable fork lift truck or pallet truck to move the pump, on its pallet, close to the place of
installation.
2. Remove all packing materials.
3. Use suitable lifting gear to remove the RUVAC WA 40000 pump from its pallet.
4. Ensure the sling centre is in line with centre of gravity which is indicated on
Figure 2 and Figure 3
Refer to Figure 4 .