Lexmark E238, Руководство по обслуживанию, Страница: 104 / 259

4511-xxx
2-72
Service Manual
84 xx 05 x1
x2 00
There was media at the input sensor too
early. There was not enough time
between printhead start and the printhead
mirror motor to lock.
(x1=input sensor state, x2=0 is normal
printhead lock expectation; 1 is lock
assumption that proved to be wrong.)
Possible causes for this error are:
• Paper might be pre-staged in the paper
source tray.
• Paper is picking too fast due to faulty
paper feed assembly.
• A defective input sensor.
200
84 xx 20 x1
x2 00
The imaged page is not the expected
page.
(x1=media size, x2=media source)
Check the pass thru sensor to make sure
it is operating properly. If no problem is
found, it may still be necessary to try a
new pass thru sensor.
200
84 xx 23 x1
x2 x3
Transfer servo never started.
(x1=media size, x2=EP leading edge
state, x3=EP trailing edge state.)
Possible causes include:
• Slow or missing transport motor
positional feedback.
• Media too fast to input sensor.
• Gap too small on interpage servo.
200
84 xx 26 x1
x2 x3
The media has activated the input sensor;
however, the printhead fell out of lock
condition or expected a stable lock too
soon. The media may have also reached
the input sensor early.
(x1=HSYNC state, x2=0 is normal PH
lock expectation;1 is lock assumption that
proved to be wrong.) 200
Sub error codes (continued)
First 6 bytes sub
error code data
(xx can be any
value)
Explanation
Possible
error
message