Lexmark E238, Руководство по обслуживанию, Страница: 102 / 259

4511-xxx
2-70
Service Manual
Sub error codes
First 6 bytes sub
error code data
(xx can be any
value)
Explanation
Possible
error
message
84 00 22 x1
x2 00
Indicates the media reached the image
point before EP leading edge state
machine was ready.
(x1=leading edge of media state,
x2=trailing edge of media state) 200
84 01 22 x1
x2 00 Media reached the image point before EP
trailing edge state printer was ready.
(x1=EP leading edge state, x2=EP trailing
edge state.) 200
84 x1 30 x2
x3 x4
Motor head transport motor error.
(x1=motore type, x2=error code,
x3=TimWatchingHallCount,
x4=TimeWatchingHallPeriod.)
84 1x 2D x2
x3 x4
Misidentified no gap jam. Engine detected
no gap at the manual feeder sensor,
attempted to open the gap by stopping
the feed rolls, trailing edge was seen at
the input sensor, manual feeder sensor is
no longer covered.
(x1+x2=page ahead’s expected length,
x3+x4=Page ahead’s measured length)
84 xx 00 x1
x2 x3
This code indicates that the input sensor
is still actuated from the first sheet, and
the second sheet is ready to arrive at the
sensor.
(x1=FsyncFall flag for Page Ahead,
x2=media source, x3=last measured gap
at input sensor).)
• Check the printer input sensor and flag
for correct operation. The flag should
operate freely.
• Check for debris in the area of the input
sensor.
• Check the area of the transfer roll and
input to the fuser for anything that might
cause the paper to remain over the
input sensor.
200