Step 10 - Install control module(s)
• Unpack the control module(s).
• Set the 3 DIP switches labeled S1 on the printed circuit board
(See Figure 8) as follows:
SW1 –down
SW2 – up
SW3 – down
• If the control module is a Remote type, verify that jumper
JP5 is in the “REM” position.
• If the control module is a Universal type, verify that the AMX/DMX switch is in the DMX position and that the Status/Other switch
is in DMX position and that the Status/Other switch is in the “Other” position. See Figure 9.
• Install the appropriate control module in the bottom slot of each pack by sliding it in until it is fully seated.
Module No.
Control Module
Type
120V
240V(Foreign Electric
Service Only)
TOPAZ 12
Remote
LEC2102
LEC2105
TOPAZ 12
Universal
600-902
600-904
3 GANG DIP SWITCH (S1) JUMPER (JP5) CONTROL FUSES (F1 – 3)
RACK NO.
THUMBWHEEL
SWITCH
POWER INDICATOR
TEST SWITCH
Figure 8 - Remote Control Module
NON-DIM SWITCHES
Figure 9 - Universal Control Module
STATUS/OTHER SWITCH AMX/DMX SWITCH
Step 11 - Set thumbwheel switch(es)
Step 11 - Set thumbwheel switch(es)
•
Set the thumbwheel switch(es) on all TOPAZ 12
control modules according to Table III on next page. See Figure 8 (Pack 1 is usually the left-most pack).
•
Set the thumbwheel switch(es) on all TOPAZ 12
control modules according to Table III on next page. See Figure 8 (Pack 1 is usually the left-most pack).
Page 7
Page 7
