Leviton PICCOLO SCAN, Руководство пользователя

Страница: 34 / 74

Leviton Piccolo Scan
28
13.2. CrossFader Playback
Cues can be played back manually by moving the X1/X2 faders or automatically by pressing the [GO]
button.
Crossfader Playback Methods:
X1/X2
Faders
The X1/X2 faders have inverted scales and are used for manual crossfades. Each new crossfade
begins when the two faders are at the same end and finishes when the faders reach the opposite
end.
X1 controls the current cue (fading it from FF to 00) and X2 controls the next cue (fading it from 00
to FF). Once the current crossfade is executed, the next crossfade is ready to start (the next new
cue in the list is assigned to X2). The X1/X2 faders can be moved at the same time for
homogeneous crossfades.
Arrow-shaped LED’s located above the faders show the direction that the faders must be moved to
complete a manual crossfade.
With a manual crossfade, programmed times are not computed.
[GO]
Button
Pressing the [GO] button starts the next crossfade automatically using the programmed times of
the cue in X2 (next cue).
It is possible to perform multiple [GO] commands: If [GO] is pressed when a crossfade in progress,
the current crossfade will finish and the next crossfade will start.
[PS.BACK]
Button
When a crossfade is in progress, pressing [PS.BACK] will pause the crossfade.
Pressing [GO] when a crossfade is paused, will start it again.
Pressing [PS.BACK] when a crossfade is paused will restore it to the previous cue (reverse
direction).
13.2.1. Modify Fade Rate
To modify the fade rate of a crossfade, press the [1_B]
RATE soft
key (LED on) and use the
encoder
wheel
to adjust the rate.
13.2.2. Modify Current Cue
To modify the current cue in the crossfader (cue in X1):
1. Make sure that X1 is at FF (otherwise command will not work).
2. Edit desired changes using the channels fader or keyboard.
3. Press [MD.FY][MD.FY].
13.3. Deleting Cues from the CrossFader
To empty all cues from the crossfader, press [DELETE][ASSIGN].