Leviton 2408CD, Руководство по установке и эксплуатации

Страница: 11 / 12

Page 13
Installation & Operation Guide Installation & Operation Guide
Page 10
Figure 4
CONTROL WIRING
Remote control connections
Special accessories manufactured by Leviton may be connected to
this dimmer, such as the 400CP control panel for doorways. See the
installation instructions that come with these accessories.
LED’S
The indicator LED’s on the dimmer firing cards indicate the status of
the dimmer.
• RED: Indicates the card is receiving DC power (both cards will
light even if only one line is energized).
• GREEN: Steady indicates a multiplex control signal is being
received. Flashing indicates that a fade, initiated from a remote
panel, is in process.
• YELLOW: Indicates a respective dimmer channel is active and
LED indicates relative intensity.
INSTALLATION
For house lighting and architectural systems
Make sure the jumper block on each control card is installed across
both jumper pins marked SPCL on the. It is also a good idea to make
sure the jumper is installed across both jumper pins marked
SOFTSTART (CD’s only).
For Stage Lighting Systems
Make sure the jumper block on each control card is NOT across both
jumper pins marked SPCL. You must also remove the SOFTSTART
jumper on each control card so the lights will not appear sluggish in
response.
NON-DIM CHANNELS
Any of the channels of the 2408 CD can be configured as NON-DIM
channels. This will cause the output of the channel to go to full on
whenever the input signal is over 10. When to input signal drops
to less than 100C; the channel output goes to full off. This is the
equivalent of a zero-crossing solid state relay.
To configure a channel for NON DIM operation simply remove the
jumper block from the pins on the firing card as indicated. Replacing
the jumper block will restore dimming operation.
CHANNEL
1
2
3
4
5
6
7
8
JUMPER BLOCK
J8
J9
J10
J11
J8
J39
J10
J11
FIRING CARD
1-4
1-4
1-4
1-4
5-8
5-8
5-8
5-8
COMMON COMMON
POWER SUPPLY I/O CARD
DMX - DMX + MCPX +15V REM + REM -
FIRING CARD
8-18 VOLT INPUTS
MPX
PWR
1 2 3 4
DIP SWITCH