14
SETUP
WALL PLACEMENT
Important:
Before drilling, check the camera placement and reception. Ensure you are hanging the camera no less than
3 ft away from baby’s crib.
1.
Pre-drill one hole in the wall using a drill bit that meets the size
of the screw.
2.
Insert a wall anchor (included) into the hole and tap gently
with a hammer until the anchor is flush with the wall.
3.
Insert the screw into the wall anchor and tighten until the
screw sticks out approximately a ½”.You may need to adjust
more than ½” to ensure the camera is snug to that wall.
4.
Connect the power cord to the power input on the camera.
5.
Locate the wall mounting hole on the bottom of the
camera base.
6.
Slide the hole over the screw on the wall until the
camera is in place.
7.
Check that the camera is secure against the wall.
Adjust the screw to ensure the camera is not loose.
8.
Connect the power cord to the wall outlet.
9.
Use wall clips (not included) to secure the power cord
away from the crib and baby’s reach.
NOTE:
When placing the camera on a wall stud, wall anchors are not required.
WARNING:
Baby monitors and cameras with power cords should never be hung on or near the crib as it is a strangulation
hazard.
Power cords should be kept no less than 3 ft away
from the crib and baby’s reach at all times.
3
ft
