Leuze MLDSET-M1, Руководство пользователя

Страница: 13 / 26

EN
13
Work steps:
Step 1: Fasten the columns to the floor

Use the base plate to determine the mounting midpoint of the column and
make a mark on the floor.

Set the drilling template on the center point, align it and mark the bore holes.

Drill the fastening holes according to instructions and insert the floor
anchors.

Set the columns up and screw them on firmly.
Step 2: Align columns

Roughly align the column using the level
1
.

Align the column to the alignment screws
2
in a vertical position using the
level.

Loosen the Allen screws
3
and align the column axially.
1
Spirit level
2
Alignment screws
3
Allen screws
4
Bore holes for floor anchors, Ø 10 mm
5
Plastic spring element with automatic resetting
Step 3: Fasten and align the Muting Sensor Sets

Select the position of the countersunk screw on the muting arm base
(1) Fixed setting:
Recommended setting with fixed 90 degree angle.

Position the countersunk screw so that it sits at the position for the
fixed setting and in the intended groove
1
and tighten it.
(2) Variable setting:
In this setting, the pitch of the arms can be adjusted with the help of the
Allen screw
5
.

Position the countersunk screw so that it sits at the position for the
variable setting
2
and tighten it.

Guide two sliding blocks into each of the slots
3

Screw the arms into the sliding blocks at the intended height and tighten the
screws securely at the fixed position or screw in loosely at the variable
position
4

Variable setting: Adjust the pitch of the sensors/reflectors with the help of
the Allen screw
5
and only then tighten the screws
4
securely. Before
realignment is performed, the screws
4
must first be loosened again.
Step 4: Establish the electrical connection

Connect the AC-SCM5-BT to the 5-pin socket of the safety sensor (local
interface).

Connect the MS1 and MS2 muting sensors to the respective socket of the
AC-SCM5-BT.

If necessary, connect additional components such as muting indicators and
start button to the AC-SCM5-BT.