Leuze ELC 100, Заметки пользователя

Страница: 9 / 41

Device/Operating mode M12 connector Connection
Transmitter 5-pin connector
Receiver 5-pin connector Connection to the ma-
chine interface
For further information on the pin assignment, see the ELC 100 operating instruc-
tions.
Testing
1 Green
2 Green/red/red
Ä Check status LEDs: continuously lit
If not as specified: troubleshoot as instructed in the ELC 100 operating instruc-
tions, chapter 10 "Diagnostics and troubleshooting".
Alignment
Ä Loosen screws on the mounting brackets.
Align transmitter or receiver by tipping, tilting and turning.
Ä
Before starting the alignment process, briefly disconnect the receiver from the
power supply.
Ä Turn the receiver from left to right until all 4 pairs of the blue alignment LEDs
illuminate permanently. As soon as this optimum point is exceeded, the blue
LEDs switch off or flash one after the other.
Ä Tighten the fastening screws of the receiver.
Ä Briefly disconnect the receiver from the power supply.
Ä Now align the transmitter according to the same method, paying attention to
the display elements of the receiver while doing so ("Display elements").
Optimum alignment:
Middle of the angle of rotation at which all 4 LEDs light up continuously.
Ä Retighten alignment screws.
9
EN