Leuze electronic GmbH + Co. KG
In der Braike 1 D-73277 Owen Tel. +49 (0) 7021 573-0
[email protected] • www.leuze.com
Switching off the computer
Information on switching off and shutting down the connected computer - which must always be performed before connecting
peripheral devices, such as a scanner - can be found in the appropriate operating instructions for your computer.
Connecting the IT 1900
Shown in the adjacent figure is the location of the cable connection and trigger
button of the scanner. The individual steps for installing the cable on the scanner
are described below.
1.
To secure the interface cable to the scanner, proceed as follows:
Insert the RJ 41 connector into the socket on the bottom of the hand-held
scanner until the connector engages.
Connect the interface cable to the appropriate connection socket on the com-
puter.
2.
You may need a power supply unit for supplying voltage; alternatively, you can
use a cable which supplies voltage from the computer system. Use the pin
assignments (see "Electrical connection" on page 1) to select the appropriate
cable for your application.
3.
Connect the power supply unit to the power socket (not necessary if voltage
is supplied from the computer).
4.
Check the operational readiness of the scanner by pointing the scanning sur-
face towards a flat surface and pulling the trigger. A red target line as well as
the red illumination should now be visible. Now scan a sample label.
The scanner emits an audible signal to confirm that the label has been read; if
necessary, the data are now passed on to the computer.
Configuration
The hand-held scanner can always be configured using bar codes. To do this, the barcode must first be selected on the package
insert and then the trigger actuated in order to read the code. The configuration is then immediately accepted and executed.
Several of the most important configurations are listed in the following.
A second option is to configure the hand-held scanner with the USB and RS232 interfaces with the aid of the
EZ Config
PC
program. You can download and install this program from our homepage at
www.leuze.de
.
The program can be used to make settings and transfer them to the hand-held scanner. The configuration can also be stored so
that it can be reused at a later time.
Further information on this can be found in the User's Guide for the IT 1900/1902.
The standard applications are described and summarised below.
Notice!
Additional information on the device and short instructions can be found on the Internet at www.leuze.de.
Cable latch
IT 1900
IT 1900
2D-code hand-held scanner
