Electrical installation
Wiring and Configuration
MC−PNC, MC−PND
4
l
42
BA_MC−Card EN 1.0
3. Exit the "cifX Driver Setup Utility" application via the
File
W
Quit
menu.
)
Note!
Only for MC−PNC (Controller):
ƒ
Configure the bus via the host application or the bus configurator
"SyCon.net".
Only for MC−PND (Device):
ƒ
Configure the bus via the warm start parameters in the "cifX Driver Setup
Utility". Further information can be obtained from the online help of the
"cifX Driver Setup Utility" and the documentation of Hilscher.
Use of the MC card in Windows
â
CE
A) IPCs
The following conditions must be met for operating the card:
1. There must be a "Config" folder on the CF card in the storage drive.
2. This folder must contain a firmware file named "Firmware.nxt".
3. The card must be configured:
– MC−PBS (MPI): Configuration via an end application.
– MC−PBM: There must be a "Config.dbm" file in the "Config" folder. Further
information on this can be found in the documentation for your FDT frame
application.
At the next system start, the driver loads the firmware and the configuration from the
"Config" folder to the communication card.
)
Note!
No special support is provided currently if you use the communication card in
your own applications. For special projects, please contact your sales office.
B) Controller
At the time the Lenze controllers can only communicate with the MC−PND via control
system, not with the MC−PNC.
In Windows
â
CE the card interact via control system. All required drivers are installed
)
Note!
No special support is provided currently if you use the communication card in
your own applications. For special projects, please contact your sales office.
