Lenze g500 Series, Инструкция по монтажу

Страница: 42 / 44

Troubleshooting and fault elimination 7
42
Lenze ¯ MA 12.0018 ¯ 2.0
7 Troubleshooting and fault elimination
If any malfunctions should occur during operation of the drive system, please check the
possible causes using the following table. If the fault cannot be eliminated by one of the
listed measures, please contact the Lenze Service.
Fault Possible cause Remedy
Drive is not running Voltage supply interrupted Check connection
Faulty electrical connection Check that supply voltage
matches nameplate data
Excessive load Reduce load
Check drive−machine
assignment
Motor is running, but
gearbox is not running
Coupling components are missing or
defective Check mounting
Gearbox is defective Inform Lenze Service
Clutch disengaged Engage the clutch
Unusual running noises Overload Reduce load
Check drive−machine
assignment
Damage to the gearbox or motor Inform Lenze Service
Excessive temperature Overload Reduce load
Check drive−machine
assignment
Inadequate heat dissipation Improve cooling air flow
Clean gearbox / motor
Lack of lubricant Top up lubricant according to
regulations
Loose fixing elements Vibrations Avoid vibrations
Oil is leaking Wrong oil level for the applied mounting
position Check mounting position
(see nameplate) and oil level
Initial insignificant leakage at the shaft
sealing ring Optimum sealing conditions
only develop after the run−in
period
Overpressure due to lacking ventilation Install ventilation according
to the mounting position
Overpressure due to polluted ventilation Clean ventilation
Worn−out shaft sealing rings Change shaft sealing rings
Cover / flange screws are loose Check that the fixing screws
are tightly fastened.
Continue to monitor the
gearbox