Lenze g500 Series, Инструкция по монтажу

Страница: 17 / 44

Mechanical installation
Preparation
General information about the assembly of drive systems
4
17
Lenze ¯ MA 12.0018 ¯ 2.0
4.3 Preparation
Note!
Thoroughly remove anticorrosion agents from output shafts and flange
faces.
4.4 Mounting
4.4.1 General information about the assembly of drive systems
Stop!
The lubricant fill quantity of the gearboxes is matched to the mounting
position. The mounting position indicated on the nameplate must be
observed to avoid damage to the gearbox.
4.4.2 Mounting the gearboxes
Draw the transmission elements onto the output shaft only by using the centering
thread.
Stop!
Shocks and blows to the shafts damage the roller bearings.
4.4.3 Mounting of g500 short/servo adapters with clamping connection
Important notes
¯ The transmission is made in a force−fitting manner via a clamping connection.
Greases, oils and other substances which reduce the friction factor reduce the
torque to be transmitted which is why these should be avoided in the connection.
¯ The motor shaft diameter must be designed with fit k6.
¯ The motor centering diameter must be designed with fit j6.
¯ With regard to smooth running tolerance of the motor shaft, concentricity of the
centering and axial runout of the mounting flange, the motor must fulfil the
requirements according to DIN 42955 R (reference values for smooth running <
0.025 mm; axial runout and concentricity < 0.05 mm).