Lenovo ThinkSystem SR635, Руководство по обслуживанию

Страница: 37 / 246

Table 13. Jumper description
Jumper name Jumper number Jumper setting
1
TPM physical
presence jumper
J10 • Pins 1 and 2: The jumper is in default setting.
• Pins 2 and 3: TPM physical presence is asserted.
2
Clear CMOS jumper J3 • Pins 1 and 2: The jumper is in default setting.
• Pins 2 and 3: Clear CMOS settings.
3
Clear password
jumper 1
J6 • Pins 1 and 2: The jumper is in default setting.
• Pins 2 and 3: Clear the power-on password.
Note:
1 The jumper is used for clearing the UEFI password. After clearing the UEFI password, you can boot
into setup to set a new password.
Internal cable routing
Some of the components in the server have internal cables and cable connectors.
To connect cables, observe the following guidelines:
• Power off the server before you connect or disconnect any internal cables.
• See the documentation that comes with any external devices for additional cabling instructions. It might
be easier for you to route cables before you connect the devices to the server.
• Cable identifiers of some cables are printed on the cables that come with the server and optional devices.
Use these identifiers to connect the cables to the correct connectors.
• Ensure that the relevant cables pass through the cable clips.
Note:
Disengage all latches, release tabs, or locks on cable connectors when you disconnect cables from
the system board. Failing to release them before removing the cables will damage the cable sockets on the
system board, which are fragile. Any damage to the cable sockets might require replacing the system board.
Chapter 2
.
Server components
27