Lenovo ThinkSystem 1610-4P, Инструкция по установке и эксплуатации

Страница: 5 / 23

- 5 -
ThinkSystem 1610-4P NVMe Switch Adapter Installation and User Guide
February 28, 2018 Chapter 1: Hardware Installation
Replacing the Bracket
Figure 1 Installing the ThinkSystem 1610-4P NVMe Switch Adapter in a PCIe Slot
5. Connect PCIe cables between the adapter and the NVMe backplane. The adapter has four SFF-8643, internal
x4, mini-SAS HD connectors. Use cables with an internal mini-SAS HD connector on one end (to connect to the
adapter) and the appropriate connector on the other end to attach to the backplane.
6. Replace the cover and reconnect any cords and cables, and power up the system.
The hardware installation of your ThinkSystem 1610-4P NVMe switch adapter is complete.
1.3 Replacing the Bracket
To replace the bracket for the ThinkSystem 1610-4P NVMe switch adapter, follow these steps:
1. At an ESD-safe workstation, remove the board from its ESD protective bag.
ATTENTION Never apply pressure to the bracket or the heat sink when inserting
the board. Do not handle the board by the bracket. Do not handle the
heat sink at any time. Do not bend or twist the board at any time.
2. Use an ESD-safe No.1 Phillips screwdriver to carefully remove the two Phillips screws that connect the
bracket to the board.
The following figure shows how to unscrew the two screws located at the top edge and
bottom edge of the board.
CAUTION Damaging the screw can void the warranty. To prevent damage to the
screw, make sure that the screwdriver is centered in the top of
the screw.
Edge of Motherboard
PCIe Slot
Bracket Screw
Press
Here
Press
Here
3_03568