Lenovo ThinkSystem 1610-4P, Инструкция по установке и эксплуатации

Страница: 6 / 23

- 6 -
ThinkSystem 1610-4P NVMe Switch Adapter Installation and User Guide
February 28, 2018 Chapter 1: Hardware Installation
Replacing the Bracket
Figure 2 Removing the Screws
3. Keep the board on a level surface to make sure you do not lose any retaining clips. The heat sink is held in
place by the same screws that attach the bracket. The black retaining clips shown in the following figure can come
loose when the screws are removed.
Figure 3 Heat Sink Held in Place by Retaining Clips Attached by Bracket Screws
CAUTION Do not move or rock the heat sink after you remove the bracket
screws. Doing so might damage the thermal interface material, which
causes the board to overheat during operation. Damage to the heat
sink or the interface material while changing the bracket might void
the board warranty.
4. Place the adapter on top of the replacement bracket. Make sure to position the bracket so that the screw holes
in the tabs are aligned with the openings in the board as shown in the following figure.
3_03569
3_03572