Lenovo ThinkServer RS140, Руководство по установке операционной системы

Страница: 27 / 44

3. When the “Microsoft Hyper-V Server 2012 R2” window is displayed, configure the language and other
options as you need, and then click Next .
4. Click Install now .
5. Read the license terms and select I accept the license terms . Click Next .
6. Select the type of installation as you need. The following steps are based on the scenario that Custom:
Install the newer version of Hyper-V Server only (Advanced) is selected in this step.
Note: If you do not need to configure RAID on your server, go to step 8.
7. If you want to install the driver for the onboard SATA software RAID or installed RAID card, do the
following:
a. In the “Where do you want to install Windows?” window, click Load driver .
b. Connect the USB storage device that contains the driver to your server, and then browse to the
folder where the driver is stored.
c. Click OK . The “Select the driver to install” windows is displayed.
d. Select Hide drivers that aren’t compatible with this computer’s hardware , and then select the
driver that you want to install on your server. Click Next .
8. In the “Where do you want to install Hyper–V Server?” window, click New .
9. Type the amount of space (in MB), and then click Apply .
10. In the “Microsoft Hyper-V Server Setup” window, click OK .
11. Ensure that the drive partition is correct, and then click Next . The installation begins.
Note: Your server will restart several times during the installation.
12. When the Administrator window is displayed, click OK and set an administrator password.
13. Press Enter. When the message
Your password has been changed
is displayed, click OK to log in to
the operating system.
Installing the driver for the chipset
To install the driver for the chipset, do the following:
1. Copy the driver for the chipset from the ThinkServer EasyStartup DVD that comes with your server to a
USB storage device. Connect the USB storage device to your server.
2. Use the following commands to install the driver:
e:
cd Chipsetwindows
cd Win7
Pnputil –i –a *.inf
Note: In the command lines, e: represents the drive letter of the USB storage device and
Chipsetwindows\Win7 represents the subdirectory where your driver is located.
3. Click Install . The installation begins.
4. Restart your server after the installation is completed.
Installing the driver for an onboard graphics card
To install the driver for an onboard graphics card, do the following:
1. Copy the driver for the onboard graphics card from the ThinkServer EasyStartup DVD that comes with
your server to a USB storage device. Connect the USB storage device to your server.
2. Use the following commands to install the driver:
e:
Chapter 2
.
Installing an operating system in legacy mode
23