Lenovo ThinkCentre M71e, Руководство по техническому обслуживанию аппаратной части

Страница: 73 / 406

Diagnostic Error Code FRU/Action
305-000-XXX Monitor DDC Test Passed
No action
305-250-XXX Monitor DDC self test failure 1. Run Setup to enable DDC
2. Cable
3. Monitor
4. Video card
5. System board
415-000-XXX Modem Test Passed No action
415-XXX-XXX Modem error Remove the Modem and re-test the system
Beep symptoms
Beep symptoms are tones or a series of tones separated by pauses (intervals without sound) during POST.
The following tables describes beep symptoms.
Beep Symptom FRU/Action
2 short beeps CMOS setting error Perform the following actions in order.
1. Start the Setup Utility program and press F10 to
Save and exit. See Chapter 6 “Using the Setup Utility
program” on page 43.
2. Start the Setup Utility program and press F9 to load
defaults and then press F10 to Save and exit.
3. Perform a Boot-block recovery. See “Recovering
from a POST and BIOS update failure” on page 392.
3 short beeps and then 1 long beep DRAM memory
error
Perform the following actions in order.
1. Make sure the memory module(s) are properly seated
in the connector(s).
2. Replace the memory module(s).
3. Replace the system board.
POST error codes
Each time you power-on the system, it performs a series of tests that check the operation of the system
and some options. This series of tests is called the
Power-On Self-Test , or POST . POST does the following
operations.
• Checks some basic system-board operations
• Checks the memory operation
• Starts the video operation
• Verifies that the boot drive is working
If the POST detects a problem, an error message appears on the screen. A single problem can cause several
error messages to appear. When you correct the cause of the first error message, the other error messages
probably will not appear on the screen the next time you turn on the system.
Chapter 7
.
Symptom-to-FRU index
67