Lenovo ThinkAgile VX2320, Руководство пользователя

Страница: 55 / 108

Hot-swap drive replacement
Follow these instructions to replace a front HDD/SSD in the ThinkAgile VX7Y13 Series appliance.
Each ThinkAgile VX7Y13 Series appliance supports solid-state-drives (SSDs) and hard-disk-drives (HDDs).
As user data are striped acrross these drives, they are referred to as data drives . While a node might be able
to self-correct for a data drive failure, it does lead to system degradation. To prevent this, always replace
failed data drives as soon as possible.
Following are the indications of a failed front HDD/SSD:
• The vSphere Web Client shows a a disk alert.
• The amber LED on the node front panel is illuminated.
Remove a hot-swap drive
Use this information to remove a hot-swap drive.
“ Read the
installation
Guidelines” on
page 47
“ ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 49
Attention: To ensure that there is adequate system cooling, do not operate the server for more than two
minutes without either a drive or a drive filler installed in each bay.
To remove a hot-swap drive, complete the following steps:
Step 1. Identify the failed drive to be replaced using the procedure
Identify Failed Disk
in
https://
storagehub.vmware.com/
.
Step 2. Prepare to replace the failed drive.
• Prepare to replace a failed cache drive using the procedure
Removing a Failed Cache Disk
in
https://storagehub.vmware.com/
.
• Prepare to replace the failed capacity drive using the procedure Removing a Failed Capacity Disk
in https://storagehub.vmware.com/ .
Step 3. Remove the hot-swap drive
a. Slide the release latch to open the drive tray handle.
Figure 17. Opening the drive tray handle of a 3.5-inch hot-swap drive
b. Grasp the handle and slide the drive out of the drive bay.
Chapter 8
.
Hardware Replacement Procedures
51