Lenovo ThinkAgile MX3321-F, Руководство пользователя

Страница: 92 / 126

Before adjusting the retainer on the M.2 backplane, locate the correct keyhole that the retainer should be
installed into to accommodate the particular size of the M.2 drive you wish to install.
To adjust the retainer on the M.2 backplane, complete the following steps:
Figure 52. M.2 retainer adjustment
Step 1. Press both sides of the retainer 1 .
Step 2. Move the retainer forward until it is in the large opening of the keyhole.
Step 3. Take the retainer out of the keyhole.
Step 4. Insert the retainer into the correct keyhole.
Step 5. Press both sides of the retainer.
Step 6. Slide the retainer backwards until it is seated in place.
Remove the M.2 backplane and M.2 drive
Use this information to remove the M.2 backplane and M.2 drive.
Chapter 4 “ Read
the
installation
Guidelines” on
page 29
“ Power off
the server
for this task”
on page 34
“ ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 31
Before removing the M.2 backplane and M.2 drive:
1. Remove the top cover. See “Remove the top cover” on page 108.
2. For easier operation, remove the riser assembly next to the M.2 backplane. See “Remove a riser card”
on page 63.
To remove the M.2 backplane and M.2 drive, complete the following steps:
Step 1. Grasp the M.2 backplane at both ends and pull it straight up to remove it from the system board.
88
ThinkAgile MX Certified Node 1UThinkAgile MX3321-H, MX3321-FUser Guide