Lenovo ThinkAgile MX3321-F, Руководство пользователя

Страница: 25 / 126

On each power supply, there are three status LEDs near the power cord connector. For information about the
LEDs, see “Rear view LEDs” on page 22.
5 NMI button
Press this button to force a nonmaskable interrupt (NMI) to the processor. By this way, you can make the
operating system halt (such as Windows Blue Screen of Death) and take a memory dump. You might have to
use a pen or the end of a straightened paper clip to press the button.
6 USB 3.0 connectors (2)
Used to attach a device that requires a USB 2.0 or 3.0 connection, such as a USB keyboard, USB mouse, or
USB storage device.
7 VGA connector
Used to attach a high-performance monitor, a direct-drive monitor, or other devices that use a VGA
connector.
8 XClarity Controller network connector
Used to attach an Ethernet cable to manage the system using XClarity Controller.
9
Ethernet connectors on LOM adapter (available on some models)
The LOM adapter provides two or four extra Ethernet connectors for network connections.
The leftmost Ethernet connector on the LOM adapter can be set as XClarity Controller network connector. To
set the Ethernet connector as XClarity Controller network connector, start Setup utility, go to
BMC Settings
➙ Network Settings ➙ Network Interface Port and select Shared . Then, go to Shared NIC on and select
PHY Card .
Figure 11. Rear view of server models with a shipping bracket
1 Shipping bracket (available on some models)
For server models with two hot-swap drive bays in the rear, if the server is installed in a rack and shipped to
you, the server comes with a shipping bracket installed.
Attention:
• Before turning on the server, ensure that you remove the shipping bracket.
• For server models with two hot-swap drive bays in the rear, if the server is installed in a rack for shipping,
be sure to install the shipping bracket.
To remove the shipping bracket, hold the two handles
1
and remove the shipping bracket from the server.
Chapter 3
.
Server components
21