Lenovo ThinkAgile CP 4000 Series, Руководство по установке оборудования

Страница: 56 / 84

Compute block connections (single-interconnect configuration)
The compute block consists of an enclosure with up to four compute nodes, which are numbered as follows:
Connect the compute nodes according to the populated compute node location and corresponding port
mapping. The cables to be used are clearly labeled; make sure that you use the correct cables.
You need two SFP+ Direct Attach Cables (DACs) for each populated compute node.
The compute block port mapping is as follows:
Front compute node location Back network port mapping Network interconnect port
Top left Compute node 3, port 1 (C.3.1) Interconnect, port 5
Compute node 3, port 2 (C.3.2) Interconnect, port 6
Top right Compute node 4, port 1 (C.4.1) Interconnect, port 7
Compute node 4, port 2 (C.4.2) Interconnect, port 8
Bottom left Compute node 1, port 1 (C.1.1) Interconnect, port 1
Compute node 1, port 2 (C.1.2)
Interconnect, port 2
Bottom right Compute node 2, port 1 (C.2.1) Interconnect, port 3
Compute node 2, port 2 (C.2.2)
Interconnect, port 4
Note: You only need to cable the number of compute nodes that are installed in the compute enclosure.
Figure 29. Single—interconnect configuration — compute node and network interconnect connections
48
Lenovo ThinkAgile CP Hardware Installation Guide