Lenovo HR630X V2, Руководство пользователя

Страница: 75 / 134

Step 5. Install the M.2 drive on the M.2 adapter.
Figure 40. M.2 drive installation
a. Insert the M.2 drive at an angle of approximately 30 degrees into the connector.
b. Rotate the M.2 drive down until the notch
1
catches on the lip of the retainer
2
.
c. Slide the retainer forward (toward the connector) to secure the M.2 drive into place.
Step 6. Connect the M.2 cables to the system board.
After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 110
OCP 3.0 Ethernet adapter replacement
Use this information to remove and install the OCP 3.0 Ethernet adapter.
Remove the OCP 3.0 Ethernet adapter
Use this information to remove the OCP 3.0 Ethernet adapter.
About this task
Attention:
• Read “Installation Guidelines” on page 27 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Chapter 4
.
Hardware replacement procedures
67