46
EN4093R 10 Gb Scalable Switch User’s Guide
Installing Feature Licenses
Once Features on Demand activation key files have been acquired, they must be
installed on the switch. The example below illustrates use of the switch CLI, but
other interfaces may also be used, such as the Browser Based Interface (BBI), or
Simple Network Management Protocol (SNMP). For more information, see the
Application Guide
and
Command Reference
for your specific switch and its installed
firmware.
When installing licenses, please note the following requirements:
•
A switch reboot is required to fully activate the license(s). If you have made any
configuration changes you wish to persist beyond the reboot, you must execute
the
copy
running-config
startup-config
command. This command
stores the current switch configuration and all changes to nonvolatile memory.
•
Both license key files can be installed prior to the switch reset in order to activate
both at the same time.
Complete the following steps to install feature licenses:
1. Log in to the switch (see
“Configuring the EN4093R” on page 33
for more
information).
2. At the switch CLI prompt, type the following command.
where
server address
is the IP address of the TFTP or SFTP file server and
file name
is the name of the licence key file as it appears in the file server
operating-system.
3. Once the key file transfer is complete, reset the switch to activate the license(s)
(see
“Resetting and Restarting the Switch” on page 44
).
EN4093R>
ena
EN4093R#
software-key
EN4093R(Software-Key)#
enakey addr
<server address>
keyfile
<file name>
protocol
{
tftp
|
sftp
} {
data-port
|
extm-port
|
mgt-port
}
