Lenovo 7Y45, Руководство по установке

Страница: 85 / 116

2. If the drive bay has a drive filler installed, remove it. Keep the drive filler in a safe place for future use.
To install a simple-swap drive, complete the following steps:
Step 1. Ensure that the tray handle is in the open position. Align the drive with the guide rails in the bay;
then, gently push the drive into the bay until the drive stops.
Step 2. Close the tray handle to lock the drive in place.
Figure 59. Simple-swap drive installation into drive bay
Step 3. Connect signal and power cable to the system board. See “Internal cable routing” on page 30 for
details.
Install a tape drive
Use this information to install a tape drive.
“
Read
the
installation
Guidelines” on
page 54
“
Power off
the server for
this task” on
page 86
“
ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 55
Before installing a tape drive:
1. Follow these steps to install the optical drive and tape drive when the M.2 drive is present.
a. When the M.2 drive is installed, ensure that SATA port 7 remains unconnected.
b. Install the optical drive into the upper media bay, Bay 1.
c. Install the backup drive (RDX or LTO tape) into the lower media bay, Bay 0.
d. Connect the optical drive to SATA port 6.
e. If an RDX drive is installed, connect the drive to the internal USB port adjacent to the M.2 drive using
the cable that shipped with the RDX drive (see “USB tape drive cable routing” on page 36).
Chapter 3
.
Server hardware setup
81