Lenovo 7Y45, Руководство по установке

Страница: 64 / 116

1.
Watch the procedure
. A video of this procedure is available from the following links:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Dy5N2dPXFx5Pht-FljAi6S
• Youku:
https://list.youku.com/albumlist/show/id_51977169
To install a hot-swap drive backplane, complete the following steps:
Step 1. Position the backplane on the drive cage so that the tabs on the drive cage are inserted into the
corresponding holes in the backplane; then, align bottom of backplane inside the bottom tabs of
the drive cage.
Step 2. While pulling the plunger, slide down the backplane until it is seated at the bottom of the drive
cage; then, close the plunger to secure the backplane into position.
Figure 39. Hot-swap drive backplane installation
Step 3. Install the drive cage into the chassis (see “Install the 3.5-inch/2.5-inch drive cage” on page 59).
Install the 3.5-inch simple-swap drive backplate
Use this information to install the 3.5-inch simple-swap drive backplate.
“
Read
the
installation
Guidelines” on
page 54
“
Power off
the server for
this task” on
page 86
“
ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 55
Before installing a simple-swap drive backplate:
1.
Watch the procedure
. A video of this procedure is available from the following links:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Dy5N2dPXFx5Pht-FljAi6S
• Youku:
https://list.youku.com/albumlist/show/id_51977169
To install a simple-swap drive backplate, complete the following steps:
Step 1. Position the backplate on the drive cage so that the tabs on the drive cage are inserted into the
corresponding holes in the backplate.
Step 2. Close the plunger to secure the backplate into position.
60
ThinkSystem ST250 Setup Guide