Lenovo 70LU, Руководство пользователя и руководство по техническому обслуживанию аппаратного обеспечения

Страница: 66 / 142

Cable From the system board To the drive
1-to-3 power cable
1
or
2
4-pin power connector
4
Power connector on the drive
Signal cable
3
SATA connector 0
5
Signal connector on the drive
Note: The 1-to-3 power cable provides three SATA power connectors 1 , 2 , and 3 . You can connect
any one of the SATA connectors to the drive.
Storage drive in drive bay 2
Drive bay 2 of your server supports a 2.5-inch/3.5-inch hard disk drive or 2.5-inch solid-state drive. For
information about drive bays and installation rules, see “Internal drives” on page 44.
• “Removing a storage drive from drive bay 2” on page 54
• “Installing a storage drive into drive bay 2” on page 54
Removing a storage drive from drive bay 2
To remove a storage drive from drive bay 2, do the following:
1. Prepare your server. See “Preparing your server and removing the server cover” on page 41.
2. Disconnect the signal cable and power cable from the drive.
3. Pull the bracket handle to slide the drive out of the drive bay.
Figure 31. Removing the drive from the drive bay
4. Flex the sides of the drive bracket to remove the drive from the bracket.
5. If you are instructed to return the old drive, follow all packaging instructions and use any packaging
materials that are supplied to you for shipping.
Installing a storage drive into drive bay 2
Note:
For a 2.5-inch hard disk drive or solid-state drive, install the drive into a 2.5-inch to 3.5-inch drive
adapter first. See “Installing a 2.5-inch drive into a 2.5-inch to 3.5-inch drive adapter” on page 45.
54
ThinkServer TS150 User Guide and Hardware Maintenance Manual