Lenovo 6290, Руководство по техническому обслуживанию аппаратной части

Страница: 10 / 136

If NO continue to
002
.
If YES proceed to
003
.
002
If the Power Management feature is enabled do the following:
1. Start the Configuration/Setup Utility program (see “IBM Setup Utility
program” on page 9)
2. Select Power Management from the Configuration/Setup Utility program
menu.
3. Select APM .
4.
Be sure
APM BIOS Mode
is set to
Disabled
. If it is not press Left Arrow (
}
) or
Right Arrow (Æ) to change the setting.
5. Select Automatic Hardware Power Management .
6. Set Automatic Hardware Power Management to Disabled .
7. If the problem persists continue to
003
.
003
Run the Diagnostic programs. If necessary refer to “Diagnostics” on page 12.
v
If you receive an error replace the part that the diagnostic program calls out or
go to
″
Symptom-to-FRU Index
″
on page 39.
v
If the test stops and you cannot continue replace the last device tested.
4
Hardware Maintenance Manual