Lenovo 4157 - ThinkStation S20 - 2 GB RAM, Руководство по техническому обслуживанию аппаратной части

Страница: 141 / 276

Note: When the computer is turned on for the first time after replacing the battery, an error message
might be displayed. This is normal after replacing the battery.
8. Turn on the computer and all attached devices.
9. Use the Setup Utility program to set the date and time and any passwords. See "Using the Setup
Utility" in the ThinkStation User Guide .
Replacing the internal speaker
Attention
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the
ThinkStation Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkStation
Safety and Warranty Guide , go to:
http://www.lenovo.com/support.
This section provides instructions on how to replace the internal speaker.
1. Remove the computer cover. See “Removing the cover” on page 76.
2. Remove the front bezel. See “Removing the front bezel” on page 80.
3. Locate the internal speaker. See “Locations” on page 77.
4. Access system board components. Note the routing of the internal speaker cable and power LED
cable, and then disconnect these cables from the system board. See “Locating parts on the system
board ” on page 111.
5. Disengage the internal speaker locking tab 3 and slide the internal speaker 1 downwards to completely
remove it from the chassis.
6. Route the new internal speaker cable and power LED cable, and then position the two internal speaker
latches 2 into the metal slots in the chassis, then push the internal speaker upwards until it snaps
into position.
Chapter 11
.
Replacing FRUs (Type 4155, 4158, 4218)
135