15
12. Mag-Mount Installation, Terminals and LEDs
CAUTION
Magnets located in this product have far-reaching and strong magnetic fields.
They could damage TVs and laptops, computer hard drives, credit and ATM
cards, data storage media, mechanical watches, hearing aids and speakers.
Keep Local Display and Mag-Mount away from devices and objects that
could be damaged by strong magnetic fields.
12.1. Installation
Access Cover
Mag-Mount without
access cover installed.
Wall Plate
(Use is optional)
Use the following procedure for installation of the Mag-Mount where existing
thermostat wiring does not exist:
a.
Unpack the Local Display and Mag-Mount (wall base).
b.
Determine the best location to install Mag-Mount. Ideal location should be
located away from outside wall, direct sunlight or discharge air vents.
c.
Cut or drill a small hole for thermostat wiring.
3/8” (10 mm)
Diameter Hole
d.
Pull about three inches of thermostat wire through the opening and remove
the outer thermostat wire jacket.
Seal wire hole in wall to prevent
cold or hot air from affecting temperature
sensor in display.
IMPORTANT
Seal wire hole in wall to prevent cold or hot air from affecting temperature
sensor in Local Display.
e.
Strip 1/4” (7 mm) insulation from end of each wire.
1/4”
f.
Use a level to align either the mag-mount or wall plate on wall horizontally.
g.
Remove cover from mag-mount by inserting a flat-head screwdriver into the
slot on each side of the mag-mount. Give it a gentle twist to separate the
two sections.
Slot
Slot
h.
Use Mag-Mount as a template to mark the desired mounting hole locations
on the wall.
