Lennox Compactair LVCK 22E, Инструкция по установке, эксплуатации и обслуживанию

Страница: 45 / 52

44
1
2
3
4
5
6
FIGURE FOR THE STANDARD UNIT CONFIGURATION FOR MODELS
44D-48D-56D-64D-76D
LOCATION
The unit can be installed outside. If it is installed, air entry and exit ducts should be fitted. Both indoor and outdoor
units should be assembled on bases previously made and stood on absorbent and antivibrating material to avoid
the vibrations being transmitted to the structure of the building.
DISCHARGE IN THE DOUBLE CIRCUIT UNITS
Always to be done through a
common duct or plenum.
Check that drain pipe connections and their fixtures are secure and that the level of the unit is tipped toward
the drain.
Inspect the state of the ducts and grilles (clean and open grilles, no breaks in the duct, etc.).
Check that the power supply is the same as stated on the Rating Plate which is in agreement with the electrical
diagram for the unit and that cable sizes are correct.
Check that tightness of the electrical connections to their terminals and to ground.
Check the control panel connections.
(If the connection is wrong, the unit will not operate and the control panel display will not light).
Inspect the Air Filter, which should be in its housing and correctly positioned (the metal grille should be toward
the inside).
Check
with your hand that the fans turn freely.
3.1.- PRELIMINARY CHECKS
3.- COMMISSIONING AND OPERATION
DISCHARGE AIR
INDOOR SECTION
CONTROL PANEL
INLET AIR DUCT
OUTDOOR SECTION
OUTDOOR
SECTION
TRAP
OUTDOOR FAN ACCESS
INDOOR SECTION
FAN ACCESS
AIR INTAKE DUCT
OUTDOOR SECTION
RETURN AIR
DUCT
FLEXIBLE JOINT AT OPENINGS
DRAIN PIPE
TRAP
DRAIN PIPE