Lennox Compactair LVCK 22E, Инструкция по установке, эксплуатации и обслуживанию

Страница: 39 / 52

38
UNIT INSTALLED ON SHOCK ABSORBERS
2.5.- UNIT LOCATION
- The unit is able to work in normal radioelectronic conditions for commercial and residential installations. For any
other conditions please consult.
- If the outside temperature in the area where the heat pump unit is to be installed is low or the cycle functioning
are too long, it may necessary to install an electrical heater, below the likely coils on the drip tray, which avoids
the causing of ice in the coil during defrost cycle.
- If the outdoor unit is going to be installed outside. It may be recommended to install isolation around the panel
of electrical box, to make sure it became hermetic.
- The bedplate is made up of two metal channels, capable
of with standing the weight of the units.
- If the unit is floor mounted, then the profiles should be
isolated with shock absorbing material such as anti-vibration
or pads. Keep in mind that fans rotate at approximately
850 rpm.
For the ones with variable pulley belts, see performances
tables.
2.- INSTALLATION
Floor supports
(shock absorbers)