INSTALLATION
CHILLER-IOM-2004-E
10
1.2.
Storage
When units are delivered on site they are not always required immediately and are sometimes put into storage. In the event of medium to long-
term storage, we recommend the following procedures:
• Ensure that there is no water in the hydraulic systems.
• Keep the heat exchanger covers in position.
• Keep protective plastic film in position.
• Ensure the electrical panels are closed.
• Keep all items and options supplied in a dry and clean place for future assembly before using the equipment.
It is strongly recommended to store units is a dry, sheltered place (in particular for units that will be installed indoor).
Storage temperature must be respected according to the information given on the rating plate.
2.
LIFTING THE UNIT
2.1.
Safety instructions
Installation, start up and adjustment of this equipment can be dangerous if certain system specific factors are ignored, such as operating
pressures, electrical components, locations (roofs, terraces and other structures located well above ground level).
Only highly qualified contractors and technicians with sound knowledge of this type of equipment, are authorized to install, start up and
service it.
During any service operations, observe the recommendations given on labels or instructions sent with the equipment, as well as any other
applicable safety procedures.
• Follow all safety rules and regulations
• Wear protective glasses and work gloves
• Handle heavy or bulky equipment carefully during lifting and moving operations, and when setting it on the ground.
CAUTION: BEFORE EACH SERVICE OPERATION MAKE SURE THAT THE UNIT POWER SUPPLY IS PROPERLY
ISOLATED AND LOCKED OUT.
NOTE: SOME UNITS MAY HAVE A SEPARATE 230V CONTROL SUPPLY THAT REQUIRES SEPARATE ISOLATION.
PLEASE CHECK THE WIRING DIAGRAM.
2.2.
Handling
Handling operations must be carried out by qualified personnel. Comply strictly with the lifting instructions as well as with any other
applicable safety procedures. Wear protective glasses and work gloves. Unit handling operations must be carried out carefully to avoid
jolting the frame, the panels, the electrical box, etc...
NOTE: The heat exchangers of the condensers could be protected from damage during transport by plastic plates. The
machine is also wrapped in packing foil. It is recommended to leave this protection in place during any transport and
lifting operations, and not to remove the plastic plates until commissioning (take care that the protecting foil wrapping is
not blown away!).
Rubber anti-vibrations mountings (AVM) & factory accessories are to be found in the control panel or in an extra box for
shipping. If the unit is mounted on anti-vibration mountings, these should be fitted to the unit before final positioning.
CAUTION: IN CASE OF REINSTALLATION OF THE UNIT, MAKE SURE THAT THE UNIT POWER SUPPLY IS PROPERLY
ISOLATED AND LOCKED OUT.
NEOSYS
HYDROLEAN & MWC
