
11. To program other equipment, repeats the Steps 1-9 for your VCR, SAT, AUD
and or your second TV or VCR or SAT.
Press the [SET] key to for 2 seconds
Press & release the [CH+]
Press the [SET] key once
Press the [DEVICE] key to select a desired mode
Press the [SET] key to save the working code
P.5
SETTING UP BY LEARNING
The RC-8-2 comes with a complete library of pre-programmed codes. After you
have set up the RC-8-2 for your device, you may find that there are one or more
keys that you had on the original remote control, which do not have a place on
the RC-8-2 keypad.
The RC-8-2 offers a special learning feature that allows you to copy almost any
function from your original remote control onto the keypad of the RC-8-2. Except
to the Macro keys, [SET] key and Device mode keys.
Before you start :
?Make sure your original remote control is working correctly.
?Make sure neither your RC-8-2, nor your original remote control is pointing at
your device.
To Learning (direct) :
For example: To copy the "PIP" function from your original TV remote control
onto the "I
I" key of your RC-8-2.
1. Place the RC-8-2 and your original remote control on a flat surface. Make
sure the ends which you normally point at your device are facing each other.
Point the original remote to the front center head of the RC-8-2 (see picture
below). Keep the remotes at a distance of 2 to 5 cm.
2. Press the [SET] key to for 2 seconds and the LCD will be shown CODE
SETUP.
3. Press & release the [CH+] key for two (2) times to view the LEARN MODE
page.
4. Upon the LCD shown as LEARN MODE, press the [SET] key once. The LCD
now shown TV IR LEARN. Press the [Device] key to select a desired mode (TV,
VCR, SAT or AUD, etc..). In this case is [TV] key.
5. Press the [SET] key once and the RC-8-2 LCD shown as TV LEARN KEY.
6. Press the "I
I" key on the RC-8-2 remote where you want to place the
learned function, the LCD shown as TV LEARNING.
7. Press & hold the key that you want to copy (Example: PIP key on your
original remote control).
8. After learning is OK, the LCD shown as SUCEESS for 3 seconds then
shown as TV LEARN KEY. If you want to copy other functions within the same
mode, simply repeat steps 6 and 7 pressing the next key you want to copy by
learning.