Preparing the implement
38
7.5
Setting the outer screw of the Optiquick adjustment centre
The outer screw (1) has been set to an ex-
treme position to save space during trans-
portation.
Adjust the outer screw (1) to the approx-
imate length of the main link (2).
Carry out fine adjustments in the field.
7.1
Clearance required for turning
Lift the plough completely before turning
it.
Check whether there is sufficient clear-
ance between the plough and the
ground for turning.
If there is insufficient clearance:
Turn the inner screw (3) to make it long-
er.
Move the cross shaft (4) to a lower posi-
tion or connect the top link in a higher
position on the plough headstock.
1
2
4
4
