
11
Rear panel
MIX B OUTPUT
Two unbalanced RCA (SWING 12) or JACK (SWING 16) connectors: this is an additional master output
which sends out the signal of the channels selected with the MUTE/MIX B buttons.
CHANNEL INSERT
Two (SWING 12) or four (SWING 16) STEREO JACK connectors: allow external devices (equalizer,
compressor, etc.) to be used to process the signal of the channels 1-2 of the SWING 12 and the channels
1-4 of the SWING 16 (see MONO INPUT CHANNEL).
+48V
+48V Phantom power supply button: activates a +48V power supply on all the MIC inputs (XLR-F
connector) of the MONO input channels, allowing condenser microphones and D.I. boxes to be powered
from the mixer.
NOTE
When the PHANTOM power supply is switched on make certain that cables with BALANCED XLR
connectors are ALWAYS used to connect the microphones: this precaution is extremely important for
avoiding damage in the event of both condenser and normal (dynamic) microphones being used
simultaneously. Switch on the phantom power supply only after having connected the condenser
microphone to the input and only with the channel fader closed to avoid output signal peaks.
Mixer on/off switch.
Power supply socket / Main fuse holder
In the event of breaking, always replace the fuse with same type and rating.
Содержание SWING12
