LEM SWING12, Руководство пользователя, Страница: 29 / 40

9
MASTER section
LEVEL SET
This LED lights when one or more SOLO button are pressed and the PFL mode is selected. This is the
typical SOLO mode used to set the input level of the channels.
OUTPUT/SOLO LEVEL
12-LED BARGRAPHS.
Allows the visualization of the signal assigned to the HEADPHONES and CONTROL ROOM outputs by
the SOLO buttons or the CR/PHONES SOURCE buttons (see point 13).
The LEDs are of three different colors:
• green = show the normal operative level of the signal (from -30 to +4 dB);
• yellow = show a high operative level of the signal (from +7 to +10 dB);
• red (CLIP) = show a too high signal level, near to the overload of the mixer output stage.
To ensure clean, distortion-free signals and to avoid damaging the components of your sound system,
try to avoid making the red LEDs lighting up repeatedly.
MIX L&R
60mm sliders for control of the general volume: controls the level of the signal arriving from the input
channel sent to the main MIX L&R outputs and to the TAPE OUT output.
MIX B
60mm sliders for control of the MIX B volume: controls the level of the signal arriving from the input
channel selected with the MUTE/MIX B button.
+48V
LED indicating when the +48V phantom power is switched on: this LED lights up when the button
on the connector panel on the rear of the mixer is pressed.
ON
LED indicating when the mixer is switched on: this LED lights up when the button on the connector
panel on the rear of the mixer is pressed.