LEM SWING12, Руководство пользователя, Страница: 28 / 40

8
TAPE IN L&R
Two RCA connectors: receive external signals from STEREO tape recorders, CD player, DAT, etc. These
inputs can be connected to the outputs of your equipment.
TAPE OUT L&R
Two RCA connectors: send out the signal taken from MIX and normally intended for STEREO recording.
These outputs can be connected to the inputs of a recorder.
MONO OUT (SWING 16 only)
Unbalanced JACK connector: sends out the sum of the MIX LEFT & RIGHT signals. The MONO output
is POST-FADER respect to the MIX L&R level control.
MONO LEVEL (SWING 16 only)
Pot for controlling the level of the MONO output.
CR/PHONES LEVEL
Pot for controlling the level of the CONTROL ROOM and HEADPHONES outputs.
When the ROUTE TO MIX switch is pressed, this pot also controls the level of the TAPE IN and the MIX
B assigned to the MIX L&R outputs.
HEADPHONES OUT
STEREO JACK headphone output connector: only stereo headphones with a minimum impedance of
200 Ohms should be connected to this output.
CR/PHONES SOURCE
Button for the selection of the signal sent to the HEADPHONES and CONTROL ROOM outputs.
These buttons allow to select the signal sent to the HEADPHONES and CONTROL ROOM outputs when
there are no SOLO switches pressed on the input channels.
a) MIX L&R: select the MIX L&R signal.
b) MIX B: select the MIX B signal.
c) TAPE IN: select the signal coming from the TAPE IN.
d) ROUTE TO MIX: allows to send to the MIX L&R the signal of the TAPE IN and the MIX B. When this
switch is pressed, the CR/PHONES pot controls the level of these signals.
ATTENTION: when ROUTE TO MIX is pressed, also the channels selected with the SOLO buttons
are sent to the MIX L&R outputs.
SOLO ACTIVE
Indicates when at least one SOLO button is pressed on the input channels.
SOLO MODE
Allows to select if the listening and the visualization of the channels selected with the SOLO buttons are
PRE-FADER (PFL) or POST FADER (AFL).
MASTER section