Dismount the cutter bar as follows.
- Place the machine on a level floor.
- Remove the securing plate (6).
- Untighten the nut M30 (7) by a few turns.
- Lift the cutter bar a few cms from the ground. Block the
hydraulics keeping the cutter bar from going down.
- Remove the nut (7) and the ring (8).
- Untighten the five bolts (14) at the bottom of the support
and remove the end plate (9).
- Slide the mower elements and intermediate spacers from
the connecting rod (3).
Assembly of the cutter bar takes place in the reversed order.
Mind the directions listed hereafter.
- Clean the centring rings (10) and the contact areas of the
mower elements and intermediate spacers.
- Make sure that there is no contamination between those
elements and spacers which were not dismounted.
- Fit the elements in the standard configuration of directions
of rotation (fig. A-2) or in a configuration at your choice
(“S” model mower discs only).
• A
RH
rotation SPLENDIMO PC element can be identi-
fied as follows.
When the hub is turned to the right (R - fig. A-3) the
drive gear on the RH side will turn
anti-clockwise
(viewed from the rear).
• A
LH
rotation element can be identified as follows.
When the hub is turned to the left (L - fig. A-3), the drive
gear on the RH side will also turn
anti-clockwise
.
Make sure that the mower discs are turned 90° in respect
of one another. If a unit can not be slid onto the drive shaft
in one go, its disc needs to be turned a semi-turn one or
several times until the unit can be placed.
Tighten the castellated nut (12) with a torque of 150-250 Nm
(15-25 kgm) and secure it with a split pin. Make sure that the
split pin does not protrude above the pressure piece.
- The securing disc (13) and supporting ring have to be fitted
in the outer mowing element. If this element is replaced,
these parts need to be moved over to the new unit.
- First, tighten the 5 bolts (14) by force of hand.
40
Supplement A
A-2
SPLENDIMO 320 PC -"N"
SPLENDIMO 320 PC -"S"
A-3
R
L
!
