4
2.
SAFETY INSTRUCTIONS
2.1
Approval
EasyAlarm®
is in compliance with R&TTE 1999/5/EC, Article 3.1a, 3.1b, 3.2 and is conform to the
following product specifications:
Safety:
EN60950,
1992+A1+A2+A3+A4
EMC:
EN
50081-1,1992
EN 50082-1, 1997 Class B
Telephone connection: CTR-21
Radio spectrum:
EN 300 220 Class1 (EA-8-8433 only)
ETS 300 683
(EA-8-8433 only)
2.2
Telephone connection
EasyAlarm®
must be connected to an analogue telephone line. Voltage of
this network (TVN=Telecommunication Network Voltage) is defined in
directive EN 41003. It is a telecommunication circuit that should not be
touched.
EasyAlarm®
can be used in configuration with approved serial terminal equipment.
This equipment has been approved to [Council Decision 98/482/EC - "CTR 21"] for pan-European single
terminal connection to the Public Switched Telephone Network (PSTN). However, due to differences between
the individual PSTNs provided in different countries, the approval does not, of itself, give an unconditional
assurance of successful operation on every PSTN termination point. In the event of problems, you should
contact your equipment supplier in the first instance"
2.3
Wireless sensors
Approval Switzerland: BAKOM 99.0135.K.P (WT-201, WT-211)
Approval other countries according to description of wireless-sensors.
2.4
Power supply
A transformer according to the safety regulation EN60950 provides power supply. 9V battery is used as a back
up in case of power failure. It is located on the rear side oft the device.
2.5
Safety notes
Do not bring the device into contact with a liquid (water).
Do not open the device (exception: opening of battery compartment).
Replace the 9V-battery as soon as the announcement “battery error” is announced.
Please note: The telephone cord must be disconnected before opening the battery compartment
because otherwise you can get in contact with the telecommunication voltage!
Check alarm functions and start a
test-call
, before the system is put in service.
Check from time to time the range of the emergency button according to section 6.5
In case that
EasyAlarm®
is used to monitor children, the supervising person must be in a suitable
distance to take immediate care for the child.
The same as above applies to handicapped persons,
EasyAlarm®
is not a substitute of a personal
care taker!
Please note, an alarm by telephone is only successful if the alarmed party takes care of the following
points:
¦
Alarm must not be answered by an answering machine or equal equipment
¦
Mobile phones can be out of range (e.g. underground car park, shielded rooms, remote areas and
so on)
¦
Take care of the charging condition of the mobile phone
¦
Loud noise can prevent you from hearing the ringer
All the electrical connections have to be potential free. Observe the regulation according to EN60950.
