18
sensor
n
activated
sensor failure
sensor
n
is in alarm mode
disconnection of sensor during operation
Alarm due to sensor
supervision
Triggered emergency call due to loss of presence
Battery error
Battery is low => battery test before
phone connection
is established
Emergency call activated
Emergency call, initiated by emergency button
Output <activated /
deactivated>
c
onfirmation of < DTMF 6 / DTMF 4 >
PIN
Request to enter PIN-Code after dialling in (remote access)
PIN error, abort
Wrong PIN-code =>
Phone connection
terminated
Power failure
Mains power loss => Mains power is tested every time before
phone
connection
is established
Programming acknowledged
Successful remote programming of a calling number or calling number
sequence
Programming, abort
Faulty remote programming of a calling number or calling number sequence
Sensor
n
activated
Announcement if sensor
n
is still in alarm mode
Supervision (I/II/III) < due to
noise / sensor
n
> activated
Confirmation of DTMF 5 : announcement of the activated supervision
functions, indicating the supervision modes in accordance to the position of
the
selection switch
(I/II/III)
Supervision (I/II/III) activated Confirmation of
DTMF 9 : Switch to
active supervision mode
an announce
monitoring functions at current position of the
selection switch
(I/II/III)
Supervision (I/II/III)
deactivated
Confirmation of
DTMF 7 : Switch to
inactive supervision mode
an
announce monitoring functions at current position of the
selection switch
(I/II/III)
Unacknowledged alarms:
n
Quantity of unacknowledged alarms
8.3
Functional checks
8.3.1
Test-call
We strongly advise to make a
test-call
to check functionality of
EasyAlarm®
before starting operation.
8.3.2
Test alarm functions
Even though the alarm unit is maintenance free (except the battery) a periodical function test should be carried
out, especially:
Emergency button
Wired sensors
Acoustical monitoring
8.4
Battery check / replacement
If the announcement „Battery error“ is initiated after switching on
EasyAlarm®
, the battery should be
replaced immediately as follows:
1.
Slide
function switch
to OFF
2.
Disconnect
EasyAlarm®
from the
telephone network, by removing the telephone cord
3.
Open battery compartment and remove old battery
4.
Insert new battery and close battery compartment
5.
Reconnect telephone cord to
EasyAlarm®
Notes:
Always use fresh 9V-batteries
Dispose the old battery properly
8.5
Maintenance
Slide
function switch
to OFF and remove telephone cord. Clean
EasyAlarm®
if necessary using a moistened
cloth and dry it afterwards.
Note:
Do not use cleaning agents or solvent
