Leister WELDPLAST S1, Руководство по эксплуатации

Страница: 29 / 116

29
Risk of burning! Let the device cool
Work environment / Safety
Before putting into operation, check power supply cord (13) and connector as well as extension
cable for electrical and mechanical damages.
The extrusion welder must not be used in areas where there is danger of explosion or flammable
materials. Ensure a safe posture during work. The power cable and filler rod must be free to move
and must not obstruct the user or third parties during work.
Place extrusion welder on a fire resistant base. Hot metal parts and hot streams of air must be
kept at a safe distance from the base and walls.
Setting the guide handle
Workplace
1
2
3
1
Loosen clamp by turning
the guide handle (6) anti-
clockwise
2
Move the guide handle (6)
into the desired operating
position.
3
Tighten clamp again by turning
guide handle (6) clockwise
Leister provides a stand for
commissioning and holding
the extrusion welder When not welding, the drive should be switched off with the drive on/off
switch (2) .
Place the extrusion welder with correspondingly set and firmly tightened
guide handle (6) on a stable, fireproof base or buffer bolt (32) as shown
in the illustration.
Guide handle
Removing/Fitting the handle
Removing the handle
1 Turn the handle (6) anticlockwise to loosen the clamp.
2
Press on the handle (6) and the gripper clamp (20) to open the lock
(see arrows). Remove the handle (6) using the gripper clamp (20) .
To fit the handle, follow the steps in reverse order.
1 2
Lock
Handle (6)
Gripper clamp (20)