20
After the welding
• Set
main switch (3)
to
I
. Push the
release switch (4)
(hot air blower running).
• Welding temperature
Set the
temperature variation knob (7)
to the desired value.
Heating up time approx. 5 minutes.
• Welding speed
– Set the welding speed determined for the particular tarpaulins and straps using the
speed variation knob (6)
.
• Joining force
– The joining force is transmitted to the D
rive roller / Pressure roller (12)
.
– If necessary, the
additional weight (22)
can be removed.
•
Drive out the hot air blower (9)
with
guide trolley (31)
, pivot up and lock in position with the
stop ring (24)
at
retaining pin (23)
.
• Set the
temperature variation knob (7)
to zero; this allows the
welding nozzle (8)
to cool off (approx. 10 minutes).
• After the
welding nozzle (8)
has cooled off, set the
main switch (3)
to
0
.
3
7
6
12
22
Caution
The machine must not be lifted on the
additional weight (22)
.
The
additional weight (22)
is not fixed in position.
4
In the case of line/mains power failure extract
hot-air blower (9)
and set
main switch (3)
to
position
0.
When the mains voltage is restored, the
main switch (3)
should be moved to
I
and the
release switch (4)
should be pushed again
Setting the welding parameters
Содержание TAPEMAT
