Leister TAPEMAT, Руководство по эксплуатации

Страница: 17 / 56

17
• Swing the guide roller (21) upwards.
• Move the hot air blower (9) outwards with the guide
trolley (31) , swing upwards and position using the
stop ring (24) to the retaining pin (23) .
24
23
21
9
31
• Check the basic setting of the welding nozzle (8) .
– The welding nozzle (8) must be aligned parallel and centrally to the Drive
roller / Pressure roller (12) and set in position.
– Clamp and stretch welding tape.
– Nozzle outlet approx. 0.5 – 1 mm gap to the stretched welding tape
(figure D) .
• Carry out the precise adjustment of the welding nozzle (8) as follows:
– Remove strap unrolling device (32) and additional weight (22) .
– Tilt the TAPEMAT Tarpaulin Bow (figure A) .
– Loosen adjustment screws (15) and push the welding nozzle (8)
upwards parallel to the pressure roller (12) , then tighten the adjustment
screws (15) again (figure B) .
– Position the outlets of the welding nozzle (8) horizontally with the
adjustment nut (14) , symmetrically to the pressure roller (12) (figure C) .
– Set the vertical height of the welding nozzle (8) to the welding tape with
the adjustment screw (13) (approx 0.5 – 1 mm gap). The height depends
on the material (figure D) .
8 12
22
32
14
13 15
Adjusting the TAPEMAT Tarpaulin Bow welding nozzle
Figure A Figure B Figure C Figure D
Transport position
• Loosen the hexagon socket screw and adjust the welding tape offset
on the side so that the tape material lies by the side of the diverting
roller (25) , then tighten the hexagon socket screw again (figure E) .
Adjusting the TAPEMAT Tarpaulin Bow diverting roller
25
Figure E