Leister TAPEMAT, Руководство по эксплуатации

Страница: 19 / 56

19
Before the welding
Connect the equipment to the mains. The mains voltage must agree with the equip-
ment voltage.
• Swing the guide roller (21) downwards.
• Set the welding parameters (see page 20).
welding temperature must be reached (heating time approx. 5 minutes).
During the welding procedure, the operator must always be on the guiding handle side and guide the
welding machine.
• Lower the hot air blower (9) and insert between the tarpaulin and the strap up to the stop.
The drive motor starts automatically by the sensor (28) .
If automatic starting does not take place adjust the sensor (see page 21).
The machine can also be started manually using the switch
Motor On/Off (5)
(1st push «Motor ON» / 2nd push «Motor OFF»).
• The automatic welding machine is guided by the guide roller (21) . Any variations can be corrected by the
guiding handle (17) . Do not apply any pressure to the guiding handle (17) since this could cause welding
faults.
• Carry out a welding test in accordance with the welding instructions from the material manufacturer and the
national standards or directives.
• Check the test weld.
24 23
3
7
5
9
31
32
34
33
22
21
28
17
4
6
8
1
FI 120
230
Performing a test weld
Welding