Leister TAPEMAT, Руководство по эксплуатации

Страница: 18 / 56

18
Threading the strap
• Remove the strap unrolling device (32) from the locator (34) .
• Insert the strap into the strap unrolling device (32) and rotate the tensioning brake disc (33) to the stop (left
hand thread).
• Insert the strap unrolling device (32) into the locator (34) .
• Adjusting the tensioning brake disc (33)
– The braking force for the various strap widths is adjusted via the
threaded pin (35) at t he tensioning brake disc (33).
– The position groove at the brass part of the tensioning brake disc (33) is
used as an adjustment aid. The mean braking force for tensioning is
achieved when the position groove is flush with the reference edge.
• Note : When the strap is not welded linear on the tarpaulin, although
the guide roller is led alongside the mark, then the braking force of the tensioning brake disc (33) must be
increased.
• Thread the strap as follows:
– Remove additional weight (22) (Figure 1) , lift the unit up and position the additional weight (22) under
the unit (Figure 2) .
– Stand on the side opposite the hot air blower (9) (Figure 3) .
– Insert the strap into the diverting rollers (25) (Figure 4) , pull under the Drive Roller / Pressure
Roller (12) and then insert into the strap retaining rollers (27) (Figure 5) . The strap retaining
rollers (27) are adjustable.
– Lift the unit, remove the additional weight (22) and hang back on the TAPEMAT.
33
35
Reference edge
Position groove
22
22
9
27
25
12
Figure 1 Figure 2
Figure 4 Figure 5 Figure 3
25 12 27