2018-08-07
Page 7
LABvault-HD
System Installation
(1) Using a slotted, pocket clip screwdriver with a
maximum tip width of 2.5mm and thickness
of .4mm, open the terminal’s tension clamp
by inserting the screwdriver tip into the
clamp’s corresponding tension release
slot (see the illustration on the right for an
example). Firmly push the screwdriver into
the slot until the clamp in the bottom of the
terminal slides open (refer to the illustration
Tension Clamp Release Slot Highlighted on a LABvault-HD
Terminal Block
Screwdriver Inserted into Tension Clamp Release Slot
Terminal
Tension Clamp
Tension Clamp
Release Slot
below).
(2) Insert the audio wire into its corresponding terminal until it is touches the bottom.
(3) While holding the wire in place, pull the screwdriver from the slot. The wire should now be clamped into
place and should not fall out of the terminal if gently tugged.
(4)
Repeat steps 5.b.ii(1)–(3) for each of the remaining terminals in your audio terminal block configuration.
iii.
Push each wired terminal block back into its slot on the rear panel of the LABvault-HD. The block only fits
one way into its holder on the rear panel
